Table of Contents
Advertisement
9 [OnePushAWC] button
Executes AWC (automatic white balance control).
Memo :
To execute [OnePushAWC], fill the screen
0
completely with a white object in a location with
lighting conditions similar to those of the subject
you are going to shoot.
Depending on the subject and lighting condition,
0
you may not achieve the desired white balance
even if you have performed [OnePushAWC]
once. In this case, perform [OnePushAWC]
again.
Even when white balance is set to "ATW-Wide"
0
or "ATW-Narrow", pressing the [OnePushAWC]
button switches the mode automatically to
AWC.
Iris
The iris is adjusted automatically when "Auto +1",
"Auto", or "Auto -1" is specified. You can also set
exposure compensation to ±1 with respect to the
auto adjustment value.
9 Mode
Auto -1:
0
Converges to a level darker than "Auto".
Auto:
0
This setting is used under general
circumstances.
Auto +1:
0
Converges to a level brighter than "Auto".
Manual:
0
Adjust the value by clicking the [+] or [-] button.
The iris value changes when the button is held
down, and stops when it is released.
[Set values: Auto -1, RAuto, Auto +1, Manual]
Back Light Compensation
Set this feature when there is a bright light source
in the same direction as the object. Enables
unwanted light sources to be excluded from the
photometry area.
9 Mode
OFF:
0
Disables backlight compensation.
Area 1 to 4:
0
Select a photometry area from the four areas.
[Set values: ROFF, Area 1, Area 2, Area 3, Area 4]
Photometry area
OFF
Area 1
Area 2
.
Memo :
0
Day/Night
Sets video to Black & White mode. Also allows you
to select from among 3 levels for automatically
activating Black & White mode in low-light
conditions.
9 Mode
0
0
0
0
0
[Set values: RColor, Black & White, Auto Low, Auto
Mid, Auto High]
Memo :
0
0
Area 3
Area 4
The backlight compensation area is not linked
to the electronic zoom.
Color:
Keeps color mode activated at all times.
Black & White:
Keeps Black & White mode activated at all
times.
Auto Low:
Switches to Black & White mode when the
subject's signal level has a low level of
brightness.
Auto Mid:
Switches to Black & White mode when the
subject's signal level has a medium level
brightness.
Auto High:
Switches to Black & White mode when the
subject's signal level has a high level of
brightness.
The mechanical sound of the infrared filter
insertion/removal can be heard when the mode
switches.
If you set "Auto Low", "Auto Mid", or "Auto High",
the camera immediately switches modes when
the set amount of illumination is detected.
[Control] -[Image Settings] Settings
93
Advertisement
Table of Contents
