Table of Contents
Advertisement
Protocol Settings
Sets the protocols.
HTTP/HTTPS
For selecting the protocol to use.
[Set values: RHTTP, HTTPS]
HTTP Server Port
You can change the port number for the built-in
HTTP server of the camera.
[Set values: 11 to R80 to 65524]
Memo :
To access the camera from Internet Explorer,
0
input the following into the Internet Explorer
address bar with the camera in the factory
default state.
http://192.168.0.2
When the port number is changed to 8080, input
the new port number after the IP address as
follows.
http://192.168.0.2:8080
Input ":" + port number
Upon changing the HTTP server port, the port
0
number for requesting video stream distribution
will also be changed.
Set [HTTP Port] of the Built-in Viewer to the
0
same value.
(A p.99 [ HTTP Port ] )
HTTPS Server Port
You can change the port number for the built-in
HTTPS server of the camera.
[Set values: 11 to R443 to 65524]
Memo :
To access the camera from Internet Explorer,
0
input the following into the Internet Explorer
address bar with the camera in the factory
default state.
https://192.168.0.2
When the port number is changed to 8080, input
the new port number after the IP address as
follows.
https://192.168.0.2:8080
Input ":" + port number
Upon changing the HTTPS server port, the port
0
number for requesting video stream distribution
will also be changed.
[Advanced Settings] Page - [Protocol] Page
76
SNMP
For setting SNMP.
[Set values: ON, ROFF]
AMX Device Discovery Protocol
You can change the AMX device detection
protocol. Set to "ON" when you are using the
camera on AMX's system.
[Set values: RON, OFF]
Standard Surveillance Protocol
Sets standard surveillance protocols.
ONVIF
You can change the standard surveillance
protocols.
[Set values: RON, OFF]
JPEG Streaming
Selects the JPEG image streaming priority.
Priority
Selects whether to give priority to the client number
for JPEG image streaming or the frame rate.
Client Number:
0
Gives priority to the streaming client number.
Lowers the JPEG frame rate as delivery
requests increase, allowing delivery to a
maximum of 20 clients.
Framerate:
0
Assigns priority to the frame rate. Set this to
maintain the frame rate for JPEG images
requested by clients. Delivery requests that
exceed the maximum number will be denied.
[Set values: RClient Number, Framerate]
Advertisement
Table of Contents
