JVC VN-H657WPBU Instructions Manual page 37

7 Connect the audio cable
Get ready a separate cable for connecting to
0
the audio device.
Connect the cable of the audio equipment
0
with the audio cable of the camera by
soldering or crimping.
Audio cable (white/white) (mic input):
0
Connect with the cable from devices such as
a capacitor microphone that supports plug-in
power.
Audio cable (light green/light green) (line
0
output):
Connect with the cable from devices such as
speakers with a built-in amplifier.
For information on the color and signal name
0
of the audio cable, refer to the following.
(A p.16 [VN-H657WPBU] )
Connect the audio cable, followed by
0
winding the waterproof tape (adhesive).
After connecting, push the audio cable into
0
the arm of the camera.
Wind the
waterproof tape
(adhesive)
.
Cable for connecting to the audio device
(microphone input/line output)
Shielded cable recommended
0
Length of 5 m or shorter recommended
0
Note :
For cables that are not used, be sure to wrap the
0
ends individually with waterproof tape
(adhesive) to ensure that waterproof treatment
is performed.
For safety reasons, turn on the power only after
0
ensuring that all the connections are in place.
Solder welding or
crimping
Insulating
tape
8 Attach the cap, and seal the cable
connection hole and areas around the
camera's mounting surface and the
four anchor bolt fasteners with a
waterproof sealant (GE silicon).
Waterproof
treatment
(x4)
Waterproof
treatment
.
Note :
Ensure that waterproof treatment is performed.
0
Otherwise, the camera may malfunction due to
rain water seepage.
Use GE silicon or other similar product for the
0
sealing material.
9 Remove the dome cover protective
sheet.
Protective
sheet
.
Installation of the camera is complete. Next, set
the IP address of the camera.
(A p.38 [IP Address Setting Procedure] )
Removing the Camera
1 Remove the waterproof sealants (GE
silicon) for sealing the cable
connection hole, areas around the
camera's mounting surface, and the
four anchor bolt fasteners .
2 Remove the cable connection cap, and
take out the cables.
3 Remove the cables, and dismantle the
camera from the wall.
Mounting the Camera (VN-H657WPBU)
Cap
37