5-Port Gigabit Ethernet Spa Overview; 5-Port Gigabit Ethernet Spa Leds - Cisco ASR 1000 Series Hardware Installation Manual

5-Port Gigabit Ethernet SPA Overview

Figure 3-16
RJ-45 connector
Table 3-11
Pin
1
2
3
4
5
6
7
8
Referring to the RJ-45 pinout in
Note
the unused Category 5 UTP cable pairs 4/5 and 7/8. Common-mode termination reduces the
contributions to electromagnetic interference (EMI) and susceptibility to common-mode sources. Wire
pairs 4/5 and 7/8 are actively terminated in the RJ-45 port circuitry in the 2-Port Copper and Optical
Gigabit Ethernet SPA.
The 2-Port Copper and Optical Gigabit Ethernet SPA supports automatic MDI/MDIX crossover at all
speeds of operation allowing the SPA to work with straight-through and crossover Ethernet cables.
5-Port Gigabit Ethernet SPA Overview
The following sections describe the 5-Port Gigabit Ethernet SPA:
•
•

5-Port Gigabit Ethernet SPA LEDs

The 5-Port Gigabit Ethernet SPA has two types of LEDs: an A/L LED for each port on the SPA, and one
STATUS LED, as shown in
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Hardware Installation Guide
3-20
RJ-45 Connector Pinouts, Plug, and Receptacle
8 7 6 5 4 3 2 1
RJ-45 Connector Pinouts
Description
DA_P (bidirectional pair A, plus)
DA_N (bidirectional pair A, minus)
DB_P (bidirectional pair B, plus)
DC_P (bidirectional pair C, plus)
DC_N (bidirectional pair C, minus)
DB_N (bidirectional pair B, minus)
DD_P (bidirectional pair D, plus)
DD_N (bidirectional pair D, minus)
5-Port Gigabit Ethernet SPA LEDs, page 3-20
5-Port Gigabit Ethernet SPA Connectors, page 3-22
Figure
Chapter 3 Overview: Cisco ASR 1000 Series Aggregation Services Routers SPAs
Table 3-11, proper common-mode line terminations should be used for
3-17.
OL-14126-15