1-Port Channelized Oc-3 Atm Ceop Spa Interface Specifications; 1-Port Channelized Oc-3 Atm Ceop Spa Optical Transceiver Modules And Cables - Cisco ASR 1000 Series Hardware Installation Manual

Chapter 3 Overview: Cisco ASR 1000 Series Aggregation Services Routers SPAs
Table 3-49
Table 3-49
LED Label
C/A
A/L
STATUS

1-Port Channelized OC-3 ATM CEoP SPA Interface Specifications

The physical layer interface for the 1-Port Channelized OC-3 ATM CEoP SPA is Optical Carrier-3
(OC-3). The total bandwidth for the SPA is 155.52 Mbps. The 1-Port Channelized OC-3 ATM CEoP SPA
can be channelized to either a maximum of 84 T1s or a maximum of 63 E1s.
The 1-Port Channelized OC-3 ATM CEoP SPA can be channelized to E1s, only when SDH framing
Note
mode is used. Channelization to T1s is possible both in SONET and SDH framing mode.
The single SPA port accepts an SFP module with a duplex LC-type receptacle that allows connection to
optical fiber.
1-Port Channelized OC-3 ATM CEoP SPA Optical Transceiver Modules and
Cables
Cisco Systems, Inc. qualifies the optics that are approved for use with its SPAs. The 1-Port Channelized
OC-3 ATM CEoP SPA supports the following types of optical transceiver modules:
•
•
•
•
•
OL-14126-15
describes the 1-Port Channelized OC-3 ATM CEoP SPA LEDs.
1-Port Channelized OC-3 ATM CEoP SPA LEDs
Color
Off
Green
Amber
Off
Green
Amber
Off
Amber
Green
Multimode (MM) SFP module (500m)—SFP-OC3-MM
Short-Reach (SR) SFP module (2 km)—SFP-OC3-SR
Intermediate-Reach (IR) SFP module (15 km)—SFP-OC3-IR1
Long-Reach (LR) SFP module (40 km)—SFP-OC3-LR1
Long-Reach 2 (LR2) or Extended Reach SFP module (80 km)—SFP-OC3-LR2
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Hardware Installation Guide
1-Port Channelized OC3 STM-1 ATM CEoP SPA Overview
State Meaning
Off Port is not enabled by software.
Port is enabled by software.
On
Port is enabled by software, and there is at least one alarm.
On
Off Port is not enabled by software.
Port is enabled by software, loopback is off.
On
Port is enabled by software, loopback is on.
On
Off SPA power is off.
On SPA power is on and good, and SPA is being configured.
On SPA is ready and operational.
3-77