Java Mobile Information Device Profile (Midp) - Cisco 7925G Deployment Manual

With the 1.4(4) release, there will be an additional parameter (speakerphone) supported (e.g. RTPRx:i:p:v:s or
RTPMRx:i:p:v:s). The s parameter is to specify which audio path the Cisco Unified Wireless Phone 7925G, 7925G-EX, and
7926G should utilize.
If s is set to 0 then the speakerphone will be utilized; unless a headset is connected, where the audio will then be played to the
headset.
If s is set to 1, then the handset or headset speaker will be utilized depending on whether a headset is currently connected or not.
If s is set to 2, then the current local mode will be utilized depending on whether speakerphone is enabled or not. If a headset is
connected, audio will always be played to the headset.
If the s parameter is not specified, then the Cisco Unified Wireless Phone 7925G, 7925G-EX, and 7926G will set the audio path
to speakerphone mode; unless a headset is connected, where the audio will then be played to the headset.
If currently on call and an XSI "call" comes in, then the current audio path will be used regardless of the s parameter value.
The audio path can be switched to the speakerphone or handset after a XSI "call" is received.
If wanting to utilize the s parameter for XSI "calls", the port and volume parameters are optional, but if not specified the colon
must still be specified for that parameter (e.g. RTPRx:10.0.0.10:20500::1, RTPRx:10.0.0.10:::1, RTPMRx:10.0.0.10:20500::1,
RTPMRx:10.0.0.10:::1).
If the port parameter is not specified, then the endpoint will select a UDP port and respond to the XSI push with that info.
If the volume parameter is not specified, then the endpoint will utilize its current volume setting.
The chart below provides a few examples of the supported XSI audio path configurations per stream type.
XSI Audio Path
Speakerphone
Handset / Headset
Speakerphone
Handset / Headset

Java Mobile Information Device Profile (MIDP)

The following document provides the information needed for Java Mobile Information Device Profile (MIDP) programmers
and system administrators to develop and deploy IP phone services.
http://developer.cisco.com/web/jmapi/home
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Deployment Guide
Stream Type
Unicast RTPRx:10.0.0.10:20500
RTPRx:10.0.0.10:20500::0
RTPRx:10.0.0.10:20500:100:0
Unicast RTPRx:10.0.0.10:20500::1
RTPRx:10.0.0.10:20500:100:1
Multicast RTPMRx:10.0.0.10:20500
RTPMRx:10.0.0.10:20500::0
RTPMRx:10.0.0.10:20500:100:0
Multicast RTPMRx:10.0.0.10:20500::1
RTPMRx:10.0.0.10:20500:100:1
RTP URI Example
129