Beamforming (Clientlink) - Cisco 7925G Deployment Manual

Beamforming (ClientLink)

Enable ClientLink if using Cisco 802.11n Access Points.
Beamforming is not supported with data rates 1, 2, 5.5, and 11 Mbps.
For releases prior to 7.2.103.0, ClientLink can be enabled globally via the 802.11 Global Parameters section or on individual
access points via the access point's 802.11 radio configuration page.
As of release 7.2.103.0, ClientLink is no longer configurable via the Cisco Unified Wireless LAN Controller's web interface
and is only configurable via command line.
With releases 7.2.103.0 and later use the following commands to enable the beamforming feature globally for all access points
or for individual access point radios.
(Cisco Controller) >config 802.11a beamforming global enable
(Cisco Controller) >config 802.11a beamforming ap <ap_name> enable
(Cisco Controller) >config 802.11b beamforming global enable
(Cisco Controller) >config 802.11b beamforming ap <ap_name> enable
The current status of the beamforming feature can be displayed by using the following command.
(Cisco Controller) >show 802.11a
(Cisco Controller) >show 802.11b
Legacy Tx Beamforming setting....................
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Deployment Guide
Enabled
69