DURKOPP ADLER 745-34 Speedpocket User Manual page 24

Error/ Info
8351
8801
-
8805
8806
8890
8891
System
Info 9001
Err 9001
Info 9002
Err 9002
9003
9601
9604
9700
9701
9710
9720
9721
9722
9723
9726
22
Meaning
Error Testpins/ Signals / Event
processing/ Memory Wrapper/ List
of functions
Internal fault
Corner knife station is swung out
Corner knife station is swung out
during the sewing process.
Step back on the pedal; afterwards
the transport carriage runs to the
back; start the process.
Folding station is swung out
Folding station is swung out during
the sewing process.
Step back on the pedal; afterwards
the transport carriage runs to the
back; start the process.
Wrong needle position before
sewing start
Pedal has been stepped back
during the sewing process
Light-barrier (s4) for fabric removal
inactive
Folder not in top position
Folder not in low position
Limit switch feeding clamp active
Error when scanning the flap by
light-barrier
Flap has been positioned in front of
the front positioning point
Flap protrudes from the maximum
sewing area (behind the rear
positioning point)
Fluff at the flap beginning
Flap too large or reflecting foil
soiled or defective
Remedy
· Switch the machine off and on again
· Software update
· Information to the DA-Service
Swing corner knife station in
Check/ adjust fastening of the corner knife
station
Swing folding station in
Check/ adjust fastening of the folding
station
Turn manually the hand wheel in lever
up position
For cancelling the pedal has to be
actuated once again.
Afterwards the feeding clamp runs in its
rear position
Adjust light-barrier (s4) for fabric removal
Correct folder adjustment (mechanical
collision; check switch S8)
Correct folder adjustment (mechanical
collision; check switch S8)
Check material feed and limit switch
Check the reflecting foil; check alignment
of the light-barriers
Position the flap correctly
Check the flap size; Position the flap
correctly
Feed flaps with smooth edges; Check the
reflecting foil
Check flap size and reflecting foil