Table of Contents
Advertisement
Chapter 5: Monitoring the Printer Status
cases you must click Resume.
Paper Out
The printer has run out of paper. Add more paper to
the paper tray.
Paper Jam
Paper has jammed inside the printer, making it impos-
sible to continue printing. Open the printer cover,
remove all paper, and close the cover.
The printer starts up again automatically once the jam
has been cleared. The printer reprints the page that
jammed before continuing with the rest of your docu-
ment.
Cover Open or Toner Cartridge Missing
Either your printer cover is open, or there is no toner
cartridge in the printer. Insert a toner cartridge if
necessary, then firmly close the printer cover.
Duplex Printing
Duplex (double-sided) mode is enabled, and the
printer has finished printing one side of your docu-
ment. Turn the sheets over and reinsert them in the
paper feeder to print the other side. Click on Resume
to continue printing.
Power Off or Cable Problem
The NEC SuperScript software cannot find your
5—4
06 Ch.5 Monitoring*
4
printer, either because the power is off, the cable is not
installed properly, or there is a problem with the
connection. Make sure the power switch is turned on,
the cable fits snugly, and nothing else is wrong with
the connection.
Engine is Warming Up
Wait until the printer's engine has finished warming
up. The NEC SuperScript will be ready to start printing
as soon as it is warmed up.
Engine Error
If there is a problem with the printer engine, call NEC
Technical Support at 1-800-632-4650. See the Appendix
on Technical Support for more information about
obtaining technical support.
96.9.24, 0:56 PM
Advertisement
Table of Contents
