Part Identification Chart - ProForm 310 Ce Elliptical User Manual

PART IDENTIFICATION CHART

Use the drawings below to identify the small parts needed for assembly. The number in parentheses below each
drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the
key number is the quantity needed for assembly. Note: If a part is not in the hardware kit, check to see if it
has been preassembled. Extra parts may be included.
M6 Locknut M8 Locknut M6 Washer
M10 Split
(77)–14 (82)–8 (35)–2
Washer (78)–6
M4 x 16mm M4 x 16mm Flat
M6 x 16mm M6 x 28mm Flat Head
Round Head Screw Head Screw (73)–4
Screw (80)–2 Bolt (31)–10
(84)–16
M6 x 36mm Button
M10 x 20mm M10 x 41mm Shoulder
Bolt (76)–4
Screw (79)–6 Screw (63)–2
5