Bowflex Xtreme 2 Assembly Instructions Manual page 11

Step 10: Attach the Seat Pad to the Seat Support Rail
Locate the following items:
• From Step 9 - Seat Backbone w/ Seat Assembly
• From Step 8 - Main Assembly
With the Seat Pad (Item #16) cushion side up, align the top
two hooks on the Seat Backbone with the lowest pair of
"pins" on the Seat Support Rail (Item #7). Tip the seat up
while engaging the hooks, and then rotate down for use.
Take care to only hook the Seat onto the lowest pins until
the Seat Back Pad is attached.
Note: Reverse this procedure to remove the Seat.
Step 11: Attach the Seat Back Pad to the Seat Support Rail
Locate the following items:
• Item #24 - Seat Back Pad
• From Step 10 - Main Assembly
• Item #E - (2) 5/16" X 2 1/2" Hex Head Bolts
• Item #N - (2) 5/16" Washers
The Seat Back Pad (Item #24) has two pair of holes on its
back. Before attaching the Seat Back Pad to the Seat
Support Rail (Item #7), assess which holes to use for your
height. The Seat Back Pad should support your middle and
upper back when you are seated.
Align the bolt holes selected for your height on the Seat
Back Pad with the two bolt holes on the Seat Support Rail.
Place (2) 5/16" Washers (Item #N) over (2) 5/16" X 2 1/2"
Hex Head Bolts (Item #E), and screw the bolts through the
aligned bolt holes, securing the Seat Back Pad tightly to the
Seat Backbone, as shown in Figure 11.
Tighten hardware from Step 11 only at this time.
Figure 10
16
Figure 11
24
7
9
7
N
E