Bowflex Xtreme 2 Assembly Instructions Manual page 10

8
Step 8: Attach the Cable Shroud to the Pulley Arms
Figure 8
Locate the following items:
• Item #23 - Cable Shroud
• From Step 7 - Main Assembly
• Item #A - (4) 4.2mm X 12mm Self Drilling Screws
13
• Item #L - (4) M4 Washers
Line up the bolt holes in the Cable Shroud (Item #23) with
A
the bolt holes in the Right and Left Pulley Arms (Items #12 23
& 13) on the Main Assembly, as shown in Figure 8.
L
Place (4) M4 Washers (Item #L) over the ends of (4) 4.2mm
X 12mm Self Drilling Screws (Item #A), and use these
screws to attach the Cable Shroud to the Pulley Arms
through the aligned bolt holes.
12
STOP! At this time, review and tighten all
hardware installed in Steps 1-8.
Step 9: Attach the Seat Pad to the Seat Backbone
Figure 9
Locate the following items:
• Item #16 - Seat Pad
D
• Item #17 - Seat Backbone
17
• Item #D - (4) 5/16" X 3/4" Hex Head Bolts
• Item #N - (4) 5/16" Washers
N
Turn the Seat Pad (Item #16) cushion side down (holes
upward), and place the Seat Backbone (Item #17) over the
Seat Pad, lining up the holes, as shown in Figure 9.
Place (4) 5/16" Washers (Item #N) over the ends of (4) 5/16"
16
X 3/4" Hex Head Bolts (Item #D) - one washer per bolt.
Tightly affix the Seat Backbone to the Seat Pad as shown
in Figure 9.
Tighten all hardware from Step 9 only at this time.