Table of Contents
Advertisement
Rear Panel
The rear panel is where you make all your connections
to the VT12 (except for the instrument jack on the top).
39. AC Power Receptacle
This is a standard 3-prong IEC power connector. Con-
nect the detachable linecord (included in the box with
your VT12) to the power receptacle on the VT12, and
plug the other end of the linecord into an AC outlet. The
VT12 has a universal power supply that can accept any
AC voltage ranging from 100 VAC to 240 VAC (50-60 Hz).
No need for voltage select switches. It will work virtually
anywhere in the world. This also means that it is less
susceptible to voltage sags or spikes, providing greater
electromagnetic isolation and better protection against
AC line noise.
40. USB
Use this jack to connect the VT12 to a computer's
USB port. This provides access to additional editing via
the VT12 Control Panel software application, as well as
saving and restoring presets. It also provides the ability
to stream cabinet-emulated audio from the amplifier
over the USB connection to allow for direct-to-computer
recording.
41. PEDAL
This RJ-45 jack is used to connect the optional PB-1
pedal board or PB-4 four-button footswitch to the ampli-
fier using a standard Category 5 (Ethernet) cable.
UNIVERSAL SUPPLY
100-240VAC 50/60Hz
USB
MAINS
AVIS: RISQUE DE CHOC ELECTRIQUE — NE PAS OUVRIR
USB/PEDAL
EXTERNAL
SPEAKER
PEDAL
4 Ohms OR GREATER
WARNING:
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT
EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE. DO NOT REMOVE COVER. NO
USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL.
42. EXTERNAL SPEAKER
Use this 1/4" TS (tip-sleeve) jack to connect an
external speaker (4 ohms or greater), for an even big-
ger sound. This jack is powered by a dedicated 30 watt
internal power amplifier. Use a two conductor speaker
cable to make this connection, not a shielded guitar
cable.
43. PHONES OUT
The 1/4" PHONES jack feeds a pair of stereo head-
phones; when the headphones are connected, the audio
output of the amplifier is muted. The headphone output
is cabinet-emulated so you hear the processed audio as
it would sound coming from the speaker.
44. PHONES LEVEL
Use this to adjust the volume of the headphones. Start
with the Phones Level turned all the way down, then
slowly turn up the Level control to a comfortable listen-
ing level.
45. LINE OUTPUT LEFT/RIGHT
These two male XLR jacks provide a balanced stereo
cabinet-emulated signal to external line-level devices.
The line outputs are always active.
PHONES
LEVEL
MAX
O O
SERIAL NUMBER
MANUFACTURING DATE
LINE OUTPUT
+4dBu BALANCED
LEFT
RIGHT
This device complies with part 15 of t
is subject to the following two condit
(1) This device may not cause harmful
(2) This device must accept any interf
C
US
3031613
interference that may cause undesire
CONFORMS TO
IEC 60065
Owner's Manual
LINE INPUT
LEFT
RIGHT
-
BAL/UNBAL
17
Advertisement
Table of Contents
