Motorola DSR-6403 Operator's Manual page 46

3
The following example shows a unit at version 0x333 that could be reverted to version 0x332.
The following example shows a unit at version 0x333 that could upgraded to version 0x334.
• The Loading message is not an executable option. If a code broadcast download is currently
in progress, the menu system will temporarily display a loading message, as shown below.
When the code download process is complete, the new code version is stored in the unit, the
loading message is removed from the menu system, and the new code version is placed in the
menu system and labeled "available." The new code version will be executed at its planned
activation time, unless the operator chooses to upgrade the unit manually, before the planned
activation time.
Note: Choosing this option and pressing ENTER does not execute any changes on the unit.
Choosing this selection before the code download is complete will cause the unit to display
the following warning message and will return the cursor to the Code Select label.
46
RESET Reset Type
E No
RESET Reset Type
E No
RESET Reset Type
E No
RESET Reset Type
E No
RESET Reset Type
E No
Upgrade has not finished loading.
Code Select
0x333 active
Code Select
0x332 available
Code Select
0x333 active
Code Select
0x334 available
Code Select
0x400 loading
This example shows the active code is 333.
If "available" is preceded by a smaller value
than the active code value, then selecting this
option will revert the unit to the previous code
version. If it is necessary to revert a unit to a
previous code version, this is typically
performed manually, using the front-panel
buttons. (A previous code version can also be
installed by a broadcast countermand
command, if the version is available.) For
details, see "To manually activate an
available code version (either revert or
upgrade)" on page 47.
This example shows the active code is 333.
If "available" is preceded by a larger value
than the active code value, then selecting this
option will upgrade the unit to the newer code
version. Typically, the newer code will be
activated automatically at the scheduled
activation time. If it is necessary to manually
upgrade this unit, see "To manually activate
an available code version (either revert or
upgrade)" on page 47.