Navi Operations - Clarion VRX928RVD Owner's Manual

NAVI Operations

NAVI functions
When Clarion Navigation (hereinafter referred to
as NAVI) is connected, the following functions
are enabled:
• Showing the NAVI display;
• Operation is available by using the panel side
buttons.
• NAVI guidance sound interruption;
• Remote operation of navigation functions by
the remote controller through the optic sensor.
If the operation of this unit is interrupted by a
NAVI operation, audio is switched to OFF.
If the operation of this unit is interrupted by a
NAVI operation when the panel is closed, the sub-
LCD display is turned to "NVG".
Setting Clarion NAVI as external
input equipment
Be sure to perform this setting after connecting
Clarion NAVI.
The factory default setting is "CLARION".
1. When the panel is open, press the [ADJ]
button to show the adjustment selection
display.
2. Touch the [z] key.
Touch the [CONNECT] key to select the
following items:
"CLARION": Setting when Clarion NAVI is
connected to the NAVI and RGB terminal.
"RGB": Setting when a RGB image of other
company's equipment is connected to the
RGB terminal.
"COMPOSITE": Setting when a composite
image of other company's equipment is
connected to the navi terminal.
"OTHERS": Setting when an external
device other than a navigation system is
connected to the VISUAL 2 terminal.
3. Touch the [CLARION] key to set connection
of Clarion NAVI.
Note:
• When the CLARION NAVI is connected with the
unit, be sure to set to "CLARION". Failure to set
to "CLARION" results in malfunction.
NAVI operation
Changeover between NAVI display and Audio/
Visual (hereinafter referred to as AV) displays.
When the panel is open, the [N/A] button has
the same function as the [N/A] button on the
NAVI remote controller to set a screen mode
and a NAVI interruption.
Operate this button to change over between
NAVI and AV displays.
When the NAVI Display/NAVI guidance sound
interruption setting (NAVI operation) is turned to
the NAVI/NAVI mode on this unit, the audio sound
is not heard.
When the [N/A] button is pressed, the screen
and audio statuses are changed cyclically as
follows:
NVG NVG + BGM
After a route calculation is done, however, the
cycle is changed as follows:
NVG NVG-INT NVG + BGM
NVG: Screen status NAVI, Audio status NAVI
NVG-INT: Screen status Audio, Audio status
audio
Note that in case of a NAVI interruption the
screen and audio statuses are both changed to
NAVI.
NVG + BGM: Screen status NAVI, Audio status
audio
Note that in case of a NAVI interruption the
audio status is changed to NAVI.
AV: Screen status audio, Audio status audio
When the NAVI display is shown with the panel
open. For the functions of the buttons for
navigation control, see "3. NOMENCLATURE".
Note:
• These buttons become normal audio operating
buttons when changing into the AV display using
the [N/A] button.
• If the receiver for remote control unit on the
CLARION NAVI is used, only the remote control
unit for NAVI comes effective and operation using
the NAVI operating buttons on the panel of the
unit cannot be performed. (For the NAVI operating
buttons, refer to the section "3. NOMENCLA-
TURE".)
• Set the NAVI side audio setting level to any
setting parameter value lower than 2.
AV NVG.
AV NVG.
59
VRX928RVD