Restoring Original Factory Settings - Garmin GPSMAP 4212 Owner's Manual

Getting Started
Card label
GPSMAP 4210 or 4212

Restoring Original Factory Settings

CaUTiON: This procedure deletes any information you have entered.
1. From the Home screen, select
> Reset.
2. Select an option:
• Select Yes to restore all factory settings.
• Select No to exit without restoring factory settings.
Viewing System Information
You can view your chartplotter's software version, basemap version, unit ID number, and your XM
WX Satellite Weather Radio ID (if available). You may need this information to update the system
®
software or purchase additional map data information.
From the Home screen, select
Using the Simulator Mode
The Simulator mode turns off the GPS receiver for use indoors or for practice. The chartplotter does
not track satellites in Simulator mode.
CaUTiON: Do not try to navigate using Simulator mode because the GPS receiver is turned off. Any
satellite signal strength bars shown are only simulations and do not represent the strength of actual
satellite signals.
1. From the Home screen select
2. Select Setup to set speed, track control (simulated heading), position, simulator time, and
simulator date.
4
Configure System
>
Configure System
> >
Configure > System
Card label
GPSMAP 4208
System Information
>
System Information.
> Simulator > On.
GPSMAP 4000 Series Owner's Manual
Factory Settings
>