Garmin GPSMAP 4012 - Marine GPS Receiver Template Manual
Flush mount template
Hide thumbs
Also See for GPSMAP 4012 - Marine GPS Receiver:
- Owner's manual (116 pages) ,
- Important safety information (48 pages) ,
- Technical reference (30 pages)
Advertisement
Quick Links
P
gPSMaP
rinting a
B
C
Notes:
(A) You must print the template on 11˝x17˝ paper. This is normally selected in the 'Printer Properties', and will differ by manufacturer.
• If your printer is not capable of printing on 11˝x17˝ paper, or you do not have 11˝x17˝ paper, you must print this template at an office
services store or similar location that has the ability to print on 11˝x17˝ paper.
(B) You must set the 'Page Scaling' setting to 'None'.
(C) Select 'Auto-Rotate and Center' to make sure the template prints in the correct orientation.
Important Information:
• Before cutting the mounting surface, measure the printout to make sure it printed at the correct size. Both the length and width
measurements are noted on the template. Verify both the length and width measurements before cutting.
• When cutting the Flush Mount template, cut inside the line, then sand and/or file the mounting surface to ensure a good fit.
4000/5000 S
®
erieS
Adobe Acrobat Print Dialog Box
F
M
t
luSh
ount
eMPlate in
a
a
dobe
crobat
A
Advertisement
Related Manuals for Garmin GPSMAP 4012 - Marine GPS Receiver
Summary of Contents for Garmin GPSMAP 4012 - Marine GPS Receiver
- Page 1 gPSMaP 4000/5000 S ® rinting a erieS luSh ount eMPlate in dobe crobat Adobe Acrobat Print Dialog Box Notes: (A) You must print the template on 11˝x17˝ paper. This is normally selected in the ‘Printer Properties’, and will differ by manufacturer. • If your printer is not capable of printing on 11˝x17˝ paper, or you do not have 11˝x17˝ paper, you must print this template at an office services store or similar location that has the ability to print on 11˝x17˝ paper. (B) You must set the ‘Page Scaling’ setting to ‘None’. (C) Select ‘Auto-Rotate and Center’ to make sure the template prints in the correct orientation. Important Information: • Before cutting the mounting surface, measure the printout to make sure it printed at the correct size. Both the length and width measurements are noted on the template. Verify both the length and width measurements before cutting. • When cutting the Flush Mount template, cut inside the line, then sand and/or file the mounting surface to ensure a good fit.
- Page 2 Pilot Hole " (9.5 mm) Trou d’implantation GPSMAP 4012/4212 ® 9,5 mm Foro guida 9,5 mm ( ”) FluSh Mount teMPlAte USE 4 mm DRILL BIT Vorbohrung UTILISATION d’un 9,5 mm ( ”) FORET de 4 mm unit dimensions: 14 "...