Daikin FTXN09KEVJU Operation Manual page 53

Installation Manual
Indoor Unit Installation
5-5. Prepare the accessory (separate product) [Figure 2].
1) Remove the cover from the accessory (separate product).
2) Insert the connection cord into connector "S21" (white) in the accessory (separate product).
3) Route each of the connection cords through the cut-outs in the accessory, then reinstall the accessory cover in its
original position.
4) Insert the accessory (separate product) connector into connector "S403" in the indoor unit electrical component box.
Then route the connection cord through the cut-out in the indoor unit electrical component box.
5-6. Install the cover of the electrical component box in its original position [Figure 3].
5-7. Install the accessory (separate product) [Figure 3].
1) Install the accessory (separate product) into the indoor unit electrical component box.
2) Route the connection cord as shown in [Figure 3].
* 5-8. Install the indoor unit electrical component box in its original position.
1) Install the louver.
2) Install the electrical component box (1 screw).
3) Install the thermistor in its original position on the heat exchanger.
4) Install the connector (S200) in its original position.
5) Connect the communication wire in its original position.
5-9. Install the front grille in its original position (2 screws).
5-10. Install the service lid (1 screw).
Figure 2: Preparing the accessory
Remove the accessory cover.
Disengage the tab.
"S21"
Figure 3: Installing the accessory
Install the accessory cover
in its original position.
10
52
Route each of the
connection cords.
Install the accessory.
Accessory
cover
Accessory
Accessory
Accessory cover
Cut-outs for the connection cords
EDUS041111_a
Insert "S403".
Route the connection
cords through the cut-outs.
Cut-out for the "S403"
connection
Cut-out for the
connection cord
Room Air Conditioners K-Series