Daikin FTXN09KEVJU Operation Manual page 164

EDUS041111_a
Removing and installing front panel
• Removal method
1)Place your fingers in the indentations on the main unit
(one each on the left and right sides), and open the panel
until it stops.
2)Continue to open the front panel further while sliding the
panel to the right and pulling it toward you in order to
disengage the rotating shaft on the left side. To
disengage the rotating shaft on the right side, slide the
panel to the left while pulling it toward you.
• Installation method
Align the tabs of the front panel with the grooves, and push
all the way in. Then close slowly. Push the center of the
lower surface of the panel firmly to engage the tabs.
Rotating shaft
Push the rotating
shaft of the front
panel into the
groove.
• Removal method
1)Remove front panel to remove the air filter.
2)Remove the screws (2) from the front grille.
3)In front of the
grille, there are 3 upper hooks. Lightly
pull the front grille toward you with one
hand, and push down on the hooks
with the fingers of your other hand.
<
When there is no work space because
the unit is close to ceiling
CAUTION
Be sure to wear protection gloves.
Place both hands under the center
of the front grille, and while
pushing up, pull it toward you.
Room Air Conditioners K-Series
Indentations on
the main unit
Removing and installing front grille
mark of the front
Upper hook
>
1) Push up.
2) Pull toward you.
Opening service lid of indoor unit
The service lid is of removable type.
• Opening method
1)Remove the single screw of the service lid.
2)Pull out the service lid frontward.
Screw
mark area
(3 locations)
Lightly pull the front
grille toward you with
one hand, and push
down on the hooks
with the fingers of your
other hand.
(3 locations)
• Installation method
1)Install the front grille and firmly engage the upper
hooks (3 locations).
2)Install 2screws of the front grille.
3)Install the air filter and then mount the front panel.
Optional Accessories
Service lid
Upper hook
Push
down.
Upper hook
163