Using The Cash Register In A Password Protected Mode; Calculator Mode - Olivetti ECR 5500 Instructions Manual

Using the Cash Register in a Password Protected
Mode
Using the Password to Access the Z Management
Mode
If a manager password was defined to protect unauthorized access to
the Z mode, proceed as follows to enter the specific password so that
you can print the Z management report:
1. Slide the control switch to the Z position.
2. Type the specific 4-digit password.
3. Press the [Amt Tend/TOTAL] key. The Z management report is
automatically printed.

Calculator Mode

The calculator mode puts the convenience of a calculator right at your
fingertips and is useful when a quick calculation is needed. It is a non-
print mode that allows the use of the numeric keys with the plus, minus,
multiply, division and equal keys. The [C] key can also be used in this
mode.
The calculator mode can only be accessed in the R1 or R2 position. It
cannot be accessed in the X or Z position nor in the middle of a sales
transaction.
If desired, you can assign a calculator mode password to restrict access
to this mode. If a password is assigned, an error tone will sound if an
attempt is made to enter the calculator mode without entering the
password.
In the calculator mode, the operational keys are limited to the following:
Key Operation
[C] Clear
[Amt Tend/TOTAL] =
[Department 1/9] + (Addition)
[Department 5/13] - (Subtraction)
[Department 2/10] x (Multiplication)
÷ (Division)
[Department 6/14]
[Numeric keys 0-9] inputting numbers
Entering the Calculator Mode
Proceed as follows to enter into the calculator mode:
1. Slide the control switch to the R1 or R2 position.
2. Hold down the [C] key and press the [Amt Tend/TOTAL] key.
3. The decimal point will appear on the far left-hand side of the display
indicating that the calculator mode is in operation.
You can now use the cash register like an ordinary calculator for
addition, subtraction, multiplication and division.
Exiting the Calculator Mode
Proceed as follows to exit from the calculator mode:
1. Slide the control switch to the R1 or R2 position.
2. Hold down the [C] key and press the [Amt Tend/TOTAL] key.
3. The decimal point will disappear from the display and a beep will
sound indicating that you are now back into the normal register mode.
31