Garmin GPSMAP 276C Owner's Manual page 17

To fi nd a land destination:
1. Be sure the GPSMAP 276C is set to Simulator Mode (see "Activating the Simulator Mode").
2. Press the FIND key.
3. Highlight 'Cities' and press
4. Use the ARROW KEYPAD to select a nearby city and press
selected 'National City, CA'.
5. With 'Go To' highlighted on the city information page, press
To simulate navigation to the destination in Automotive Mode:
1. Follow the steps above to fi nd a destination city. The GPSMAP 276C switches to the Map Page. A
magenta line shows the auto route from your current location to your 'Go To' destination. If desired,
press IN or OUT to adjust the zoom level.
2. Press to return to the Map Page. Press
QUIT
the position marker (triangle) as the unit simulates navigation. If desired, press
the simulated navigation on the other main pages.
Continue to use the Simulator to practice navigation as needed. When you are ready to navigate on
your own, don't forget to turn the Simulator off before you start.
To turn off the Simulator:
1. Turn the unit off by pressing and holding the red
2. Turn the unit back on by pressing and holding the red
Mode.
NOTE:
You can activate and deactivate the Simulator through the Setup Tab of the Main Menu
or by pressing MENU while on the GPS Tab of the Main Menu.
.
ENTER/MARK
ENTER/MARK
ENTER/MARK
to adjust the zoom level. Observe the movement of
IN
POWER key.
POWER
. For our example, we
.
PAGE or QUIT to view
key. The unit powers on in Normal
Getting Started
Simulated Basic Navigation
Simulated navigation displayed on the Map Page
( Automotive Mode)
Simulated Current Route Page ( Automotive Mode)
11