Getting Ready To Sew; Connecting Machine To Power Supply; Before Usingyour Sewing Machine; For Your Safety - Kenmore 385.15510200 Owner's Manual

SECTION II. GETTING READY TO SEW
Connecting Machine to Power Supply
(_ Power supply plug
Power switch
Outlet
Machine socket
(_ Machine plug
(_ Light bulb
Before connecting the power cord, make sure the voltage
and frequency shown on the machine conform to your
electrical power.
1. Turn off the power switch _.
2. Insert the machine plug _ into the machine socket _.
3. Insert the power supply plug (_ into the outlet _.
4. Turn the power switch _ to turn on the power and
sewing light (_.
Before
UsingYour Sewing
Machine
Before using your sewing machine for the first time, place a
waste fabric under the presser foot and run the machine
with thread for a few minutes. Wipe away any oil which may
appear.
For Your
Safety
* While in operation, always keep your eyes on the sewing
area. Do not touch any moving parts, such as the thread
take-up lever, handwheet or needle.
* Always turn off the power switch and unplug from the
power supply:
- When leaving the machine unattended
- When attaching or removing any parts
- When cleaning the machine
* Do not place anything on the foot control, when not
sewing.
Polarized
Plug
This appliance has a polarized plug (one blade wider than
the other). To reduce the risk of an electric shock, this plug
is intended to fit in a polarized outlet only one way. If the
plug does not fit in the outlet, reverse the plug. If it still does
not fit, contact a qualified electrician to install the proper
outlet. Do not modify the plug in any way.
Foot Controller Model YC-482J-1 or TJC-150 is used with
Sewing Machine Model 385.15510XXX (XXX represents
numbers OOO through 999).
S
s
\
\
Controlling Sewing Speed
Sewing speed can be varied by the foot control.
The harder you press on the foot control, the faster the
machine runs.
S
6