Using Tls In Vista; Figure 44 Vista Security: Enter Credentials; Figure 45 Vista Security: Additional Information Required - ZyXEL Communications G-202 User Manual

ZyXEL G-202 User's Guide

Figure 44 Vista Security: Enter Credentials

Note: If you are not sure what to enter, contact your network administrator.
7 Click OK. The Enter Credentials screen disappears and the G-202 tries to connect to
the network. The ZyXEL utility's Link Info screen displays, showing the connection
status (see
connection, you have successfully completed the procedure.

4.6.2 Using TLS in Vista

Take the following steps to set up WPA, WPA2 or 802.1x security using TLS in Windows
Vista.
1 Either select the AP to which you want to connect in the Site Survey screen (see Section
4.3 "The Site Survey Screen" on page 52), or configure a profile (see Section 4.4 "The
Profile Screen" on page 60) in the normal way.
2 In the WPA, WPA2 or 802.1x security screen, select TLS as the EAP Type. Note that
the Login Name and Certificate fields are greyed-out (not available).
3 Click Next.
4 In the Summary screen, click Save.
5 A message similar to the following appears in the bottom-right of your screen. Click the
message.

Figure 45 Vista Security: Additional Information Required

6 The Select Certificate screen displays. Select the certificate you want to use in order to
authenticate with the server, and enter your username.
70
Section 4.2 on page 50). If the Link Info screen displays an active
Chapter 4 Wireless Station Mode Configuration