Security Settings In Windows Vista; Using Peap In Vista; Figure 43 Vista Security: Additional Information Required - ZyXEL Communications G-202 User Manual

4.6 Security Settings in Windows Vista

When you use the G-202 in Windows Vista, the procedure for setting up WPA, WPA2 and
802.1x security settings is different from that of other operating systems (other security types
are not affected).
The procedures for setting up WPA, WPA2 or 802.1x in Vista are the same. However, the
procedure differs depending on whether you use PEAP (Protected Extensible Authentication
Protocol) or TLS (Transport Layer Security) encryption. Consult your network administrator
if you are unsure which type of encryption to use.
See section Section 4.6.1 "Using PEAP in Vista" on page 69 to use PEAP, or see section
Section 4.6.2 "Using TLS in Vista" on page 70 to use TLS.

4.6.1 Using PEAP in Vista

Take the following steps to set up WPA, WPA2 or 802.1x security using PEAP in Windows
Vista.
1 Either select the AP to which you want to connect in the Site Survey screen (see
4.3 on page
2 In the WPA, WPA2 or 802.1x security screen (see
Section 4.3.1.4 on page
and Password fields are greyed-out (not available).
3 Click Next.
4 In the Summary screen that appears, click Save.
5 A message similar to the following appears in the bottom-right of your screen. Click the
message.

Figure 43 Vista Security: Additional Information Required

6 The Enter Credentials screen displays. Enter your User name and Password for the
network to which you want to connect.
Chapter 4 Wireless Station Mode Configuration
52), or configure a profile in the normal way (see
57), select PEAP as the EAP Type. Note that the Login Name
ZyXEL G-202 User's Guide
Section 4.4 on page
Section 4.3.1.3 on page 56
Section
60).
and
69