Installation And Connection - Beko Oven Manual

Room size
3
smaller than 5 m
3 3
5 m to 10 m
3
greater than 10 m 'den not required
In the cellar or
basement

Installation and connection

Product can only be installed and connected in
accordance with the statutory installation rules.
Do not install the product next to
refrigerators or freezers. The heat emitted
by the product will increase the energy
consumption of cooling appliances.
• Carry the product with at least two persons.
• Product must be placed directly on the floor.
It must not be placed onto a base or a
pedestal.
Do not use the door and/or handle to carry
or move the product. The door, handle or
hinges get damaged.
Electrical connection
Connect the product to a grounded outlet/line
protected by a fuse of suitable capacity as stated
in the "Technical specifications" table. Have the
grounding installation made by a qualified
electrician while using the product with or without
a transformer. Our company shall not be liable for
any damages that will arise due to using the
product without a grounding installation in
accordance with the local regulations.
DANGER
The product must be connected to the
mains supply only by an authorised and
qualified person. The product's warranty
period starts only after correct
installation.
Manufacturer shall not be held responsible
for damages arising from procedures
carried out by unauthorised persons.
Ventilation opening
2
min. 100 cm
2
min. 50 cm
2
min. 65 cm
DANGER
The power cable must not be clamped,
bent or trapped or come into contact
with hot parts of the product.
A damaged power cable must be replaced
by a qualified electrician. Otherwise, there is
risk of electric shock, short circuit or fire!
The mains supply data must correspond to the
data specified on the type label of the product. The
rating plate is either seen when the door or the
lower cover is opened or it is located at the rear
wall of the unit depending on the unit type.
Power cable of your product must comply with the
values in "Technical specifications" table.
DANGER
Before starting any work on the electrical
installation, disconnect the product from
the mains supply.
There is the risk of electric shock!
Connecting the power cable
1. If a power cable is not supplied together
with your product,a power cable that you
would select from the table in accordance with
the electrical installation at your home must be
connected to your product by following the
instructions in cable diagram.
This product must only be connected by a qualified
electrician such as a technician from the local
electricity company or NICEIC registered contractor
to a suitable double-pole control unit with a
minimum contact clearance of 3 mm in all poles.
This control unit must be installed in accordance
with the IEE directives. Failure to obey this
instruction may cause operational problems and
invalidate the product warranty.
This product must only be installed by a qualified
electrician eg local electricity company or NICEIC
registered contractor to a suitable double-pole
control unit with a minimum contact clearance of
3mm in all poles and with a minimum rating
please consider technical data table, Technical
specifications, page 5 which should be fitted
adjacent to (but not above) the cooker in
accordance with IEE regulations. Failure to observe
this instruction may result in operational problems
and invalidation of the product warranty.
12 / EN