Troubleshooting - Beko Oven Manual

8

Troubleshooting

Oven emits steam when it is in use.
It is normal that steam escapes during operation. This is not a fault.
Water drops occur during cooking
The vapour that arises during cooking can condense and form water droplets when it hits cold surfaces of the
product. This is not a fault.
Product does not operate.
The mains fuse is defective or has tripped.
Oven light does not work.
Oven lamp is defective.
Power is cut.
Oven does not heat.
Function and/or Temperature are not set.
In models equipped with a timer, the timer is not
adjusted.
(In products with microwave oven, timer controls only
microwave oven.)
Power is cut.
There is no gas.
Main gas valve is closed.
Gas pipe is bent.
There is no ignition spark.
No current.
Timer is not set.
Burners are not burning properly or at all.
Burners are dirty.
Burners are wet.
Burner cap is not mounted safely.
Gas valve is closed.
Gas cylinder is empty (when using LPG).
(In models with timer) Clock display is blinking or clock symbol is on.
A previous power outage has occurred.
Consult the Authorised Service Agent or the dealer where you have purchased the product if you can
not remedy the trouble although you have implemented the instructions in this section. Never attempt
to repair a defective product yourself.
27/ EN
Check fuses in the fuse box. If necessary, replace or
reset them.
Replace oven lamp.
Check if there is power. Check the fuses in the fuse
box. If necessary, replace or reset the fuses.
Set the function and the temperature with the Function
and/or Temperature knob/key.
Adjust the timer.
Check if there is power. Check the fuses in the fuse
box. If necessary, replace or reset the fuses.
Open gas valve.
Install gas pipe properly.
Check fuses in the fuse box.
Set the timer.
Clean burner components.
Dry the burner components.
Mount the burner cap properly.
Open gas valve.
Replace gas cylinder.
Adjust the timer / Switch of the product and switch it
on again.