Installation And Connection - Beko CSS 52001 D User Manual

or door available for room ventilation, an extra
ventilation must be installed.
The appliance may be located in a kitchen,
kitchen/diner or a bed-sitting room, but not in a
room containing a bath or shower. The appliance
must not be installed in a bed-sitting room of less
than 20m°.
Do not install this appliance in a room below
ground level unless it is open to ground level on at
least one side.
Ventilation opening
smaller than 5 m
5 m to 10m
greater than 10 m"'den
In the cellar or min. 65 cm
basement
Installation and connection
Product can only be installed and connected in
accordance with the statutory installation rules.
Do not install the appliance next to
refrigerators or freezers. The heat emitted
by the appliance will lead to an increased
energy consumption of cooling appliances.
e Carry the product with at least two persons.
e Product must be placed directly on the floor.
It must not be placed onto a base or a
pedestal.
Material damage!
{The door and/or handle must not be used
for lifting or moving the appliance.
Electrical connection
Connect the product to a grounded outlet/line
protected by a fuse of suitable capacity as stated
in the "Technical specifications" table. Have the
grounding installation made by a qualified
electrician while using the product with or without
a transformer. Our company shall not be liable for
any damages that will arise due to using the
product without a grounding installation in
accordance with the local regulations.
11/EN
Risk of electric shock, short circuit or fire
by unprofessional installation!
The appliance may be connected to the
mains supply only by an authorized qualified
person and the appliance is only guaranteed
after correct installation.
‚Risk of electric shock, short circuit or fire
by damage of the mains lead!
The mains lead must not be clamped, bent
or trapped or come into contact with hot
parts of the appliance.
lf the mains lead is damaged, it must be
replaced by a qualified electrician.
The mains supply data must correspond to the
data specified on the type label of the product. The
rating plate is either seen when the door or the
lower cover is opened or it is located at the rear
wall of the unit depending on the unit type.
Power cable of your product must comply with the
values in "Technical specifications" table.
Power cable plug must be within easy reach
dafter installation (do not route it above the
Before starting any work on the electrical
installation, please disconnect the appliance
from the mains supply.
Plug the power cable into the socket.
Gas connection
„Risk of explosion or poisoning by
unprofessional installation.
The appliance may be connected to the gas
distribution system only by an authorized
qualified person who is Gas Safe registered.
\ Risk of explosion!
Before starting any work on the gas
installation, please shut off the gas supply.