Table of Contents
Advertisement
5-1. Partially install two canopy screws (about 2 full turns) in the
hanger bracket.
5-2. Raise the canopy over the hanger bracket (For low profi le
installations, you will need to remove the canopy from the hook
fi rst). Align partially installed screws with key slots in canopy.
5-3. Twist canopy clockwise to secure.
5-4. Install third canopy screw in round hole on canopy. Securely
tighten all three screws.
5-5. Using both hands, push the canopy trim ring up to the top of the
canopy. e canopy trim ring will snap and lock into place.
Should you need to remove the canopy
trim ring, follow these steps:
1. Locate the tab indicators, small
bumps on top of tabs.
2. Press fi rmly on opposite sides of the
ring towards the canopy. e tabs
will fl ex out releasing the trim ring
from the canopy
42027-01 • 12/09/05
5 • Installing the Canopy and Canopy Trim Ring
Steps 5-1 – 5-2
Canopy
Steps 5-4 – 5-5
Hanger Bracket
Canopy Trim
Ring
9
Step 5-3
Canopy
Screw
Hunter Fan Company
Advertisement
Table of Contents
