Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Hunter 42008-01
Summary of Contents for Hunter 42008-01
- Page 1 42008-01 • 12/07/05...
-
Page 2: Table Of Contents
• Read this entire manual carefully before beginning installation. Save these instructions. • Use only Hunter replacement parts. • To reduce the risk of personal injury, attach the fan directly to the support structure of the building according to these instructions, and use only the hardware supplied. - Page 3 Understanding Mounting Hunter’s patented mounting system provides you maximum installation fl exibility and ease. You can install your Hunter fan in one of two ways, depending on your preference: Standard or Angle mounting. e steps in this manual include instructions for both mounting methods.
-
Page 4: Getting Ready
• Drill holes for and install wood screws. • Identify and connect electrical wires. • Lift 40 pounds. If you need help installing the fan, your Hunter fan dealer can direct you to a licensed installer or electrician. Gathering the Tools You will need the following tools for installing the fan: •... -
Page 5: Installing The Hanger Bracket
For proper alignment use slotted holes directly across from each other. If you are installing the fan on an angled ceiling, be sure to orient the hanger bracket with the large opening towards the ceiling peak. -
Page 6: Assembling And Hanging The Fan
3-1. Remove the label from the standard mounting washer inside the canopy. Leave the washer in place. 3-2. To assemble the fan to hang down from a flat or angled ceiling, insert the downrod through the canopy. 3-3. Feed the wires from the fan through the downrod. -
Page 7: Wiring The Fan
4-1. Disconnect the power by turning off the circuit breakers to the outlet box and associated wall switch location. 4-2. Decide how you want to set up the fan and light controls. You can control the fan and/or lights together or separately using one or two wall switches. -
Page 8: Installing The Canopy
5-1. Raise the canopy over the hanger bracket. Align partially installed screws with key slots in canopy. 5-2. Twist canopy clockwise to secure. 5-3. Install third canopy screw in round hole on canopy. Securely tighten all three screws. 42008-01 • 12/07/05... -
Page 9: Assembling The Blades
Hunter fans use several styles of fan blade irons (brackets that hold the blade to the fan). 6-1. Your fan may include blade grommets. If your fan has grommets, insert them by hand into the holes on the blades. 6-2. Attach each blade to a blade iron using three blade assembly screws. -
Page 10: Installing The Switch Housing
7-6. To attach the lower switch housing, thread the thumb screws through the side holes of the upper switch housing and tighten them securely. Note: You can customize your Hunter fan with a number of accessory light kits. umbscrew Steps 7-5 –... -
Page 11: Operating And Cleaning Your Ceiling Fan
8-1. Turn on electrical power to the fan. 8-2. e fan pull chain controls power to the fan. e pull chain has four settings in sequence: High, Medium, Low and Off. • Pull the chain slowly to change settings. • Release slowly to prevent the chain from recoiling into the blades. -
Page 12: Troubleshooting
1. If your fan wobbles when operating, use the enclosed balancing kit and instructions to balance the fan. 2. Tighten all blade iron screws. 3. Turn power off , support fan very carefully, and check that the hanger ball is properly seated. If you need parts or service assistance, please call 888-830-1326 or visit us at our WEB site at http://www.hunterfan.com.