• Read this entire manual carefully before beginning installation. Save these instructions. • Use only Hunter replacement parts. • To reduce the risk of personal injury, attach the fan directly to the support structure of the building according to these instructions, and use only the hardware supplied.
Page 3
Understanding Mounting and Installer’ s Choice® Hunter’s patented 3-position mounting system provides you maximum installation flexibility and ease. You can install your Hunter fan in one of three ways, depending on ceiling height and your preference: Low Profile, Standard, or Angle mounting. The steps in this manual include instructions for all three Installer’s Choice mounting methods.
• Drill holes for and install wood screws. • Identify and connect electrical wires. • Lift 40 pounds. If you need help installing the fan, your Hunter fan dealer can direct you to a licensed installer or electrician. Gathering the Tools You will need the following tools for installing the fan: •...
Tighten the screws into the 9/64” pilot holes; do not use lubricants on the screws. Do not over tighten. Flat Washer 42404-01 • 01/04/10 • Hunter Fan Company Isolator Ceiling Plate Step 2-2...
3-4. Align the holes in the washer with the holes in the adapter. Assemble securely with three #8-32 x 3/4” screws. 3-5. Raise the fan and align the slots in the canopy with the tabs on the ceiling plate. WARNING: Fan may fall if not assembled as directed in these installation instructions.
4-8. Return to the fan so you can complete the fan wiring. Steps 4-2 – 4-3 Steps 4-4 – 4-5 3mm (1/8") Support Brace Outlet Box Braided Ceiling Cable 42404-01 • 01/04/10 • Hunter Fan Company Step 4-1 Steps 4-6 – 4-7...
5-1. Disconnect the power by turning off the circuit breakers to the outlet box and associated wall switch location. 5-2. Decide how you want to set up the fan and light controls. You can control the fan and/or lights together or separately using one or two wall switches.
WARNING: Failure to complete this step could cause fan to fall. 6-2. Lift the fan and align the canopy screw holes with the mounting holes on the ceiling plate. 6-3. Partially install a canopy screw into the side opposite the ceiling plate tabs.
Use without grommet Blade Mounting Screw 42404-01 • 01/04/10 • Hunter Fan Company Hunter fans use several styles of fan blade irons (brackets that hold the blade to the fan). 7-1. Your fan may include blade grommets. If your fan has grommets, insert them by hand into the holes on the blades.
Align the side screw holes in the upper and lower switch housings. Attach the lower switch housing to the upper switch housing with three housing assembly screws. 42404-01 • 01/04/10 • Hunter Fan Company 8 • Installing the Light Kit Steps 8-1 – 8-3 Steps 8-5 –...
Page 12
Step 8-7 – 8-8 Thumb Screw 42404-01 • 01/04/10 • Hunter Fan Company 8-7. To install the glass shades, insert each glass shade in a shade cup. 8-8. Install and tighten the three thumbscrews. Do not over tighten. 8-9. Install medium base incandescent light bulbs (60 watt maximum each).
9 • Operating and Cleaning Your Ceiling Fan 9-1. Turn on electrical power to the fan. 9-2. The fan pull chain controls power to the fan. The pull chain has four settings in sequence: High, Medium, Low and Off. • Pull the chain slowly to change settings.
Problem: Lights shut off suddenly 1. Turn the power to the fan off at the wall switch. Wait 30 seconds, then resume power to the fan. 42404-01 • 01/04/10 • Hunter Fan Company 10 •...