Installing The Hanger Bracket - Hunter 42027-01 Installation And Operating Manual

2-1. Drill two pilot holes into the wood support structure through the
outermost holes in the outlet box. e pilot holes should be 9/64"
in diameter.
Note: Your fan comes with four pre-installed neoprene noise
isolators.
2-2. read the lead wires from the outlet box down through the hole
in the middle of the hanger bracket.
2-3. Align the slotted holes in the hanger bracket with the pilot holes
you drilled in the wood support structure. For proper alignment
use slotted holes directly across from each other. If you are
installing the fan on an angled ceiling, be sure to orient the hanger
bracket with the large opening towards the ceiling peak.
Note: e isolators should be flush against the ceiling.
2-4. Place a flat washer on each of the two 3" screws and pass the
screws through the slotted holes in the hanger bracket into the
pilot holes you drilled.
Tighten the screws into the 9/64" pilot holes; do not use lubricants
on the screws. Do not over tighten.
Flat Washer
42027-01 • 12/09/05
2 • Installing the Hanger Bracket
Isolator
Hanger
Bracket
Step 2-3 (Angled Ceiling Only)
3" Screw
For Angled Ceilings: Be sure to orient
the hanger bracket with the large
opening towards the ceiling peak.
5
Steps 2-2 – 2-4
Hunter Fan Company