Hunter 42027-01 Installation And Operating Manual page 14

7 • Completing Your Installation With or Without a Light Fixture (Continued)
Uninstalling the Light Fixture
1. Disconnect the plug connectors.
2. Uninstall the nut and washer from the end of the light fi xture inside
the lower switch housing.
3. Remove the light fi xture from the lower switch housing pulling
disconnected wires through the hole in the center of the lower
switch housing.
4. Locate the no-light assembly. Place the pipe from the assembly into
the lower switch housing. Install the nut and washer (removed in
step 3) onto the pipe to secure the no-light assembly to the switch
housing.
5. Install the lower switch housing to the upper switch housing with
three screws.
Attaching  e Pull Chain Pendent
Insert the end of the fan pull chain between
14
the hooks on the pull chain pendant. Pull tight
to capture the link between the hooks.
Hunter Fan Company
Nut and
Lower
Washer
Switch
Housing
Light Fixture
Step 2
Step 4
Nut and
Washer
Lower
Switch
Housing
No-light
Assembly
Step 5
42027-01 • 12/09/05