Step 2 - Installing The Ceiling Plate - Hunter 41462-01 Installation And Operation Manual

®
STEP 2 - INST STEP 2 - INST
STEP 2 - INSTALLING THE CEILING PLA STEP 2 - INST STEP 2 - INST
W W W W W ARNING ARNING ARNING ARNING ARNING
• To avoid possible electrical
shock, before wiring fan,
disconnect power by turn-
ing off the circuit breakers
both to the outlet box and
to its associated wall switch
location. If you cannot lock
the circuit breakers in the
off position, securely fasten
a prominent warning de-
vice, such as a tag, to the
service panel.
8
ALLING THE CEILING PLA ALLING THE CEILING PLA
ALLING THE CEILING PLA ALLING THE CEILING PLATE
1. Drill two pilot holes into the wood
support structure through the
outermost holes on the outlet
box. The pilot holes should be
9/64" in diameter by 2 3/4" in
depth.
2. Thread the lead wires from the
outlet box through the hole in the
middle of the ceiling plate.
3. Position the three isolators be-
tween the ceiling plate and ceil-
ing by inserting the raised areas
on each isolator into the holes in
the ceiling plate. Refer to Figure
2a.
4. Align the slotted holes in the ceil-
ing plate with the pilot holes in
the wood support structure.
Note: The isolation pads should
be flush against the ceiling.
TE TE
TE TE
Isolators
Ceiling
Plate
Figure 2a - Adding Isolators to Figur Figur e 2a - Adding Isolators to e 2a - Adding Isolators to e 2a - Adding Isolators to
Figur Figur e 2a - Adding Isolators to
Ceiling Plate Ceiling Plate Ceiling Plate Ceiling Plate Ceiling Plate
41462-01 10/14/2005