Step 7 - Assembling Fan Blades - Hunter 41462-01 Installation And Operation Manual

STEP 7 - ASSEMBLING FAN BLADES

STEP 7 - ASSEMBLING FAN BLADES
STEP 7 - ASSEMBLING FAN BLADES STEP 7 - ASSEMBLING FAN BLADES STEP 7 - ASSEMBLING FAN BLADES
1. Attach each blade to the blade
iron using three barrel nuts and
three decorative screws as shown
in Figure 7a, 7b and 7c.
Decorative
Screw
Barrel Nut
Figur Figur Figur Figur Figure 7a - Attaching Blades to Blade e 7a - Attaching Blades to Blade e 7a - Attaching Blades to Blade e 7a - Attaching Blades to Blade e 7a - Attaching Blades to Blade
Ir Ir Ir Ir Iron on on
on on
41462-01 10/14/2005
Blade
Barrel Nut
Blade
Iron
Figur Figur Figure 7b Figur Figur e 7b e 7b e 7b e 7b
2. Remove the blade mounting
screws and rubber shipping
bumpers from the motor.
3. Align the holes in the blade
bracket and the cover plate with
the five holes in the bottom of
the motor and partially install
the five 1/4"-20 Screws. Refer
to Figure 7c.
4. Once all five screws are partially
installed, tighten them securely.
Decorative
Screw
Failure to securely tighten the
1/4"-20 Screws into the Motor
Blade
could cause the Blade Assem-
Iron
bly to fall.
Figure 7c - Attaching Blade Ir Figur Figur Figur Figur e 7c - Attaching Blade Ir e 7c - Attaching Blade Iron e 7c - Attaching Blade Ir e 7c - Attaching Blade Ir
Assembly to Motor Assembly to Motor
Assembly to Motor Assembly to Motor Assembly to Motor
®
WARNING WARNING WARNING WARNING WARNING
Blade
Bracket
Cover
Plate
Blade
Bracket
Assembly
Screws
on on on on
15