Setting The Clock - A&D UA-767PC Instruction Manual

Setting the Clock

The UA-767PC blood pressure monitor is equipped with a date and time function.
To set the clock on the monitor, follow these steps:
Press the clock button on the front of the monitor.
The blinking digits reflect the year. If they are not currently set on the correct year,
press the START button to advance to the correct year. The clock is set to show
years 1999 through 2098. If you pass the correct year, continue advancing the
clock until you have run through the cycle of years and are back at the correct
year.
Year
To set the month and day, press the clock button again.
The month numeral(s) will blink. Press the START button to advance the numbers
to the correct month. Press the clock button again to advance to the day setting.
When the numbers reflecting the day of the month blink, press the START button
to advance the numbers to the correct day.
Month/Day
When you press the clock button again, the display will change and the time will
be shown in the same format as a digital clock, with the hour numerals blinking.
To set the correct hour, press the START button to advance the numbers to the
correct hour. To set the minutes, press the clock button again. The minute setting
will blink. Press the START button to advance the minutes until you reach the
correct setting. Press the clock again. The hour and minute display appears. This
is the standby mode.
Hour/Minute
6