Setting The Clock - A&D AND TM-2657P Instruction Manual

To set the date and time, use clock setting mode. Clock setting mode has the following display.
Year
Month
Day
Hour
Setting the date and time:
Use the following buttons.
SELECT button:
▲ button:
START/STOP button: Once the desired date and time is selected, press the START/STOP button
COUNT button:
Example: Setting the clock to 4:37 PM, April 20, 2015
1. Hold the SELECT button for 1 second. The systolic display section starts flashing.
2. Press the ▲ button to display
3. Press the SELECT button. The diastolic display section starts flashing.
4. Press the ▲ button to display
5. Press the SELECT button. The pulse display section starts flashing.
6. Press the ▲ button to display
7. Press the SELECT button to select the hour on the clock display. The hour setting starts
flashing.
8. Press the ▲ button to display
9. Press the SELECT button to select the minute on the clock display. The minute setting starts
flashing.
10. Press the ▲ button to display
11. Press the START/STOP button to return to standby mode.
Notes
If no operation is performed for about 10 seconds, the specified settings are set.
After is displayed for 2 seconds, the monitor returns to the standby mode.
Dates up to December 31, 2050 are supported.

SETTING THE CLOCK

8.
SYS
mmHg
Selected item
flashes
DIA
mmHg
PUL
/min.
Hour Minute
1. While the monitor is in standby mode, hold the SELECT button for 1
second to enter clock setting mode. The year value will start flashing.
2. Press the SELECT button to select the date or time value to be set.
Each time the SELECT button is pressed, the flashing value changes from
year, month, day, hour, minute, and then back to year. The selected item
flashes and can be changed.
Change the selected (flashing) values.
to save the changes and return to standby mode.
If the COUNT button is pressed while configuring settings, changes are not
saved and the monitor returns to standby mode.
. (2015)
. (April)
. (20th)
. (4 PM)
. (37 minutes)
15