Notes For Proper Measurement - A&D UA-705 Instruction Manual

When a measurement is made with an
erratic pulse or in a very noisy
environment,
7. Turning the power off
Press the
START
The device will be in standby mode.
8. Subsequent measurements
If a subsequent measurement is required, turn off the power and turn it on
again. When "0 " is displayed, the device is ready for another measurement.
Note: Allow at least three minutes between measurements on the same
person.
9. Automatic power-off function
If the device is left on after a measurement, it will turn off automatically
after about one minute. It may be turned off at any time by pressing the
button.
START

Notes For Proper Measurement

Sit down in a comfortable position. Place the arm to be used for the
measurement on a table or other support so that the center of the cuff will be
at the same height as your heart.
Relax for about five or ten minutes before taking a measurement. If you are
excited or depressed by emotional stress, the measurement will reflect this
stress as a higher (or lower) than normal blood pressure reading and the
pulse reading will usually be faster than normal.
Your blood pressure varies constantly, depending on what you are doing and
what you have eaten. What you drink can have a very strong and rapid effect
on your blood pressure.
This device bases its measurements on the heartbeat. If you have a very
weak or irregular heartbeat, the device may have difficulty determining your
blood pressure.
Should the device detect a condition that is abnormal, it will stop the
measurement and display an error symbol. Refer to page 4 for the
descriptions of the symbols.
This blood pressure device is intended for use by adults only. Consult with
your physician before using this device on a child. A child should not use this
device unattended.
will display.
button to turn the power off.
English 8