Measurements; Measurement With Storing Data - A&D UA-705 Instruction Manual

Measurement With Storing Data

1. Place the cuff on the arm (preferably the left
arm).
Sit quietly during measurement.
2. Press the
START
The buzzer sounds and the average
blood pressures
classification and last data number are
displayed briefly.
When the " 0 " is flashing, the device is
ready for measurement. If the
displayed, the cuff has some air trapped
in it. Press the exhaust valve button until
the mark is displayed.
3. Pressurize the cuff by squeezing the rubber
bulb.
A pressure bar indicator and the current
pressure are displayed.
Stop squeezing the rubber bulb when the
mark disappears.
Note: If you want to stop inflation at any time,
stop squeezing the rubber bulb and
press the exhaust valve button to expel
the air from the cuff.
4. When inflation is complete, deflation starts
automatically and the buzzer sounds and
the (heart mark) blinks, indicating that
the measurement is in progress. Once the
pulse is detected, the mark flashes and
the buzzer sounds with each pulse beat.
5. When the measurement is complete,
the buzzer sounds and the
displayed. The systolic and diastolic
pressure readings and pulse rate are
displayed and stored.
6. Press the exhaust valve button to
completely release air from the cuff.
When a measurement is made with
insufficient pressure, the
be displayed. Re-pressurize the cuff.
Stop squeezing the rubber bulb when
the mark disappears.

Measurements

button.
and the WHO
mark is
mark is
mark will
English 7