Omega Freedom 400 Owner's Manual page 32

by unplugging, then plugged back together, the system's 9-wire harness, or by
removing and then restoring the Blue 15 Amp fuse on the system's Red main
power wire, which is also located at the control unit and siren assembly. The
Freedom-400 may be operated by up to two transmitters.
Step 1: After ensuring the system's Blue wire is non-grounded, remove and then
restore power to the system. The siren will chirp once, and the parking
lights, if connected, will flash 6 times.
Step 2: Immediately upon the single siren chirp, press and release the "Small"
Button on the first transmitter. The system will respond with one chirp.
Step 3: Within 6 seconds, press and release the "Small" Button on the second
transmitter to be programmed. The response will be one, then another
chirp, which indicates both transmitters have been programmed, and the
system is exiting Transmitter Programming Mode.
Should only one transmitter be programmed, after 6 seconds of no programming
activity the system will sound two chirps and automatically exit Transmitter Pro-
gramming Mode. Also, if only one transmitter is programmed, one preexisting
transmitter code will be retained. Should it be desired to purge the preexisting
code, simply program the single new transmitter twice into the system.
Page 21