Omega Freedom 400 Owner's Manual page 20

the security system. Connecting this wire will prevent the system from being
armed while the ignition switch is on, and its connection is required if the Valet/
Override is installed for the purpose of allowing the system to be disarmed without
the transmitter (an "Emergency Override").
CONNECTION: This connection should be made to the primary ignition circuit.
Primary ignition has 0 Volts when the ignition key is in the "Lock", "Off" and
"Accessory" positions; and +12 Volts in the "Run" and "Start" positions. Make this
connection at the engine compartment fuse/junction block, or (less desirable),
locate the correct wire at the ignition system and securely splice the Yellow wire
to it. Another option is to carefully route this wire through the firewall, and make
the connection at the ignition switch wiring harness, being sure to test the target
wire as described at the beginning of this section.
Gray Wire - (Valet/Override Switch Input): This wire is a - Negative input, and
connects to the Valet/Override Switch. This wire and the Pink wire are somewhat
related in function, and also related in routing and connection.
Pink Wire - (Status Indicator Light Output): This wire is a Positive output, and
connects to the Status Indicator Light. This wire and the Pink wire are to routed
from the control unit and siren assembly into the vehicle's interior compartment.
Installation Insert Page 9