Omega Freedom 400 Owner's Manual page 22

Status Indicator Light: Mount the Status Indicator Light using the combination
holder, or it may be mounted into an interior panel by drilling a 17/64" (6.5mm) hole.
The control module and siren assembly's Pink wire must be routed to the Status
Indicator Light's mounting location.
Once the Gray and Pink wires are connected, ground both of the devices' Black
wires using the supplied ring terminal. Mount the combination in a location where
it can easily be seen by the driver, and preferably where it can be seen from
outside, as the LED Status Light provides a level of visual deterrence. The location
should also be easily accessible to the driver should the need arise to perform an
Emergency Override. Show the user the Valet/Override Switch location.
Orange Wire - (Negative Output For Optional Starter Interrupt): The Orange
wire is for an optional starter disable socket and relay, and/or an optional DM-1
power doorlock interface (which includes its own instructions). The function of this
wire is to provide a 500mA - Ground Output whenever the security system is in an
armed state. In the starter interrupt application, this output supplies - Ground to
one side of the relay's coil. The other side of the relay coil will be supplied with +12
Volts from the ignition switch, but only if the ignition switch is turned to the "start"
position. If this occurs, the coil will energize, activating the relay, which in turn will
open the starter circuit. The starter interrupt prevents the vehicle from starting only
Installation Insert Page 11