Wiring Connections - Omega Freedom 400 Owner's Manual

After the control unit and siren assembly has been mounted, follow the instructions
for each wire's connection. Please note that during the initial installation, as
soon as the Black ground wire and Red Constant power wire have been
connected, the system will enter Transmitter Programming Mode, which is
explained on Pages 20-21. As the included transmitters are already programmed
at the factory, no action is needed, and simply allow Transmitter Programming
Mode to automatically time itself out after 6 seconds.

Wiring Connections

The Freedom-400 is a uniquely engineered design; it can be installed and have
basic operations with the connection of only two of it's nine wires. The connection
and utilization of its remaining wires greatly adds to the operational sophistication
of this system, and it also features two independent parking light wires.
Of the system's nine wires, the Red, Black, two Whites, and Yellow wires in most
cases can be connected within the engine compartment. The Blue wire, if it is
connected to a hoop pin switch only, will also remain within the engine compart-
ment. If it is to also be connected to a trunk pin switch, or possibly the dome light
circuit to protect the doors, will need to be routed into the vehicle interior through
the firewall. The Gray, Pink and Orange wires will need to be routed through the
firewall and into the vehicle interior.
Installation Insert Page 2