Oki ML6300FB-SC User Manual page 29

ITEM
Auto CR
*IBM PPR only
SI Select Pitch (10CPI) *IBM
PPR/AGM only
SI Select Pitch (12CPI) *IBM
PPR/AGM only
Reset Inhibit
Select Language Set
*EPSON only
Impact Mode
Print Direction Command
Power Saving
Power Save Time
PE Detection
Table Print
Line Spacing
Page Width
Form Tear-Off
Skip Over Perforation
FUNCTION
Select whether to perform
auto CR operation upon
receiving a carriage return
command.
Set how to handle an SI
command received in 10 CPI
mode.
Set how to handle an SI
command received in 12 CPI
mode.
Set whether to enable or
disable an initial command.
Set whether to enable or
disable a combination of the
code page setting and the
language setting by menu.
Select print mode on power
on. (This item is referred to
on initialisation only by I-
PRIME or power on but not by
an initialisation command.)
Select the validity of a one-
way print setup command.
Set whether to enable or
disable power save mode.
Set idle time to enter power
save mode.
Select whether to detect
paper end or not.
Set whether to divide a path
or not to print on occasions
when printing by the same
headpin continues for 3 in or
more in the same print block.
Select line feed pitch.
Set width of a line to
determine the number of ANK
(10CPI) characters to be
printed. With this setting, the
right margin is set. For
reduced-size prints, at 75%
or 50%, 136 characters are
printed.
Select manual or auto as the
method to advance a
continuous form to the form
tear-off position.
Select whether to skip over
perforation or not. (When a
skip over perforation setup
command is received, the
received command is given
priority.)
Operating instructions > 29
SETTING
Yes
No
15 CPI
17.1 CPI
12 CPI
20 CPI
No
Yes
Combined
Code Page Only
Normal
Quiet
Hi Copy
Valid
Invalid
Enable
Disable
5 min, 10 min, 15 min, 30
min, 60 min
OFF
ON
Standard
Special
6 LPI
8 LPI
10.6 in
8 in
Off
500 ms
1 sec
2 sec
Yes
No