Use Address Pools; Apply / Cancel; Configuration | System | Address Management | Pools; Ip Pool Entry - Cisco VPN 3000 User Manual

Use Address Pools

Check this box to have the VPN Concentrator assign IP addresses from an internally configured pool.
If you use this method, configure the IP address pools on the Configuration | System | Address Management
| Pools

Apply / Cancel

To include your settings in the active configuration, click Apply . The Manager returns to the Configuration
| Address Management
Reminder: To save the active configuration and make it the boot configuration, click the Save Needed icon at the
top of the Manager window.
To discard your settings or changes, click Cancel . The Manager returns to the Configuration | Address
Management

Configuration | System | Address Management | Pools

This section of the Manager lets you configure IP address pools from which the VPN Concentrator
assigns addresses to clients. If you check Use Address Pools on the Configuration | System | Address
Management | Assignment
in the pools must not be assigned to other network resources.
Figure 6-3: Configuration | System | Address Management | Pools screen

IP Pool Entry

The IP Pool Entry list shows each configured address pool as an address range; e.g., 10.10.147.100 -
10.10.147.177
order they are configured. The system uses these pools in the order listed: if all addresses in the first pool
have been assigned, it uses the next pool, and so on.
VPN 3000 Concentrator Series User Guide
screens below.
screen.
screen.
screen above, you must configure at least one address pool. The IP addresses
. If no pools have been configured, the list shows --Empty-- . The pools are listed in the
Configuration | System | Address Management | Pools
6-3