Intel ECB-862 Series User Manual page 72

Note:
The computer cannot receive or transmit data until the computer and application are
fully running. After the item is set as enabled, the system must enter to OS once
before system is turned off.
4.5.6.15 Wake up on LAN
This allows you to remotely power up your systems through your network by sending a
wake-up frame or signal. With this feature, you can remotely upload/download data to/from
systems during off-peak hours. Set to Enabled to set this feature. Please refer to session
2.4.6 for more information.
The choice: Disable, Enable.
4.5.6.16 USB KB Wake-up From S3
If your USB KB supports PME (Power Management Event) signal and this item is set as
Enabled, USB KB peripherals drive PME signal to wake the system from low-power states
S3.
The choice: Disable, Enable.
4.5.6.17 Resume by Alarm
Set this option to enable or disable the RTC Alarm to Wake Up the system, which is set at
soft off.
The choice: Disable, Enable.
4.5.6.18 Date (of Month) Alarm, Time (hh:mm:ss) Alarm
Alarm time on Date / Hour / Minute / Second.Set these options to specify the RTC
4.5.6.19 Primary/Secondary IDE 0/1, FDD, COM, LPT Port & PCI PIRQ [A-D] #
These items enable or disable the detection of IDE, floppy, serial, parallel port and PCI
PIRQ [A-D] activities for power down state transition. Actually it detects the read/write
to/from I/O port.
The choice: Disable, Enable.
ECB-862/862L User's Manual 61
ECB-862/862L