Integrated Peripherals Setup Defaults - Intel ECB-862 Series User Manual

Intel pentium ii full-size picmg cpu card with 4 usb 2.0, audio, & dual 10/100 base-tx ethernet

Table of Contents

User's Manual

4.5.5

Integrated Peripherals Setup Defaults

This section describes I/O resources assignment for all of on-board peripheral devices.

4.5.5.1

On-Chip Primary/Secondary PCI IDE

Select "Enabled" to activate each on-board IDE channel separately, Select "Disabled", if

you install an add-on IDE Control card.

The choice: Enable, Disable.

4.5.5.2

IDE Primary & Secondary Master/Slave PIO

These four PIO fields let you set a PIO mode (0-4) for each of four IDE devices. When

under "Auto" mode, the system automatically set the best mode for each device.

The choice: Auto, Mode 0, Mode 1, Mode 2, Mode 3, and Mode 4.

4.5.5.3

IDE Primary & Secondary Master/Slave UDMA

When set to "Auto" mode, the system will detect if the hard drive supports Ultra DMA mode.

The choice: Auto, Mode 0, Mode 1, Mode 2, Mode 3, and Mode 4.

54 ECB-862/862L User's Manual

Figure 5: The Integrated Peripherals Features

Table of Contents