Kenmore 106.5117 Use & Care Manual page 29

Hide thumbs Also See for 106.5117:
Table of Contents

Advertisement

Available languages

Available languages

GENERAL OPERATION
PossibleCauses and/or Recommended Solutions
Refrigerator
seems noisy
The compressor in your new refrigerator
regulates temperature
more efficiently
and uses less
energy than older models. During various stages of operation,
you may hear normal operating
sounds that are unfamiliar.
The following noises are normal.
Buzzing/Clicking
- Heard when the water valve opens and closes to dispense water or fill the
ice maker. If the refrigerator
is connected to a water line, this is normal. If the refrigerator
is not
connected to a water line, turn off the ice maker.
Cracking/Crashing
- Heard when ice is ejected from the ice maker mold.
Popping - Heard when the inside walls contract/expand,
especially during initial cooldown.
Pulsating/Whirring
- Heard when the fans/compressor
adjust to optimize performance
during
normal operation.
Rattling - Heard when water passes through the water line, or due to the flow of refrigerant.
Rattling may also come from items placed on top of the refrigerator.
Water running or gurgling - Heard when ice melts during the defrost cycle and water runs into
the drain pan.
Sizzling
- Heard
when water
drips
onto
the heater
during
the defrost
cycle.
Temperature is too warm
New installation
- Following installation, allow 24 hours for the refrigerator
and freezer to cool
completely.
NOTE. Adjusting the temperature
control(s) to the coldest setting will not cool either
compartment
(refrigerator
or freezer) more quickly.
Doors are opened often or not closed completely - This allows warm air to enter the
refrigerator.
Minimize
door openings, keep the doors fully closed, and make sure both doors
are properly sealed.
Air vents are blocked - Remove items that are immediately
in front of the vents.
Large amount of warm food recently added - Allow several hours for the refrigerator
to return
to its normal temperature.
Controls are not set correctly for the surrounding conditions - Adjust the controls to a colder
setting. Check the temperature
again in 24 hours.
Temperature is too cold
Controls are not set correctly for the surrounding conditions - Adjust the controls to a warmer
setting. Check the temperature
again in 24 hours.
Top refrigerator
shelf is colder than lower shelves - On some models, air from the freezer enters
the refrigerator
compartment
through vents near the top refrigerator
shelf. As a result, the top
shelf can be slightly colder than lower shelves.
Air vents are blocked - Remove items that are immediately
in front of the vents.
Interior moisture buildup
NOTE" Some moisture buildup is normal. Clean with a soft dry cloth.
Room is humid - A humid environment contributes to moisture buildup. Use the refrigerator
only
in an indoor location, with as little humidity as possible.
Doors are opened often or not closed completely - This allows humid air to enter the
refrigerator.
Minimize
door openings, keep the doors fully closed, and make sure both doors
are properly sealed.
Interior lights do not work
Doors have been open for an extended period of time - Close the doors to reset the lights.
Light bulb is loose in the socket or has burned out - On models with incandescent
interior light
bulbs, tighten or replace the bulb. See "Lights."
NOTE: On models with LED lights, call for assistance or service if the interior lights do not
illuminate when either door is opened. See either the front cover or the Warranty
for contact
information.
29

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

10651173310

Table of Contents