Kenmore 106.5117 Use & Care Manual page 23

2.
NOTE: It is not necessary to turn the ice maker control to the
OFF (right) position when removing the storage bin. The _;_@_ r_ _/_";_._.G_'_ R_gidi_
sensor cover ("flipper door"), located on the right wall of the (oY__;_:e_'_e _ e_;_e:_
freezer door, stops the ice maker from producing ice if the
door is open or the storage bin is removed. To Remove and Replace the Bottle/Can Rack.
/ !it .-- o,onro
2. Replace the bottle/can rack by sliding it in above the
desired supports and pushing it down until it stops.
........ lii ..............
Replace the bin by sliding it onto the door, then tilting it
back into an upright position. The release lever will click
when the bin is securely in place.
REFRIGERATOR FEATURES
B. Sensor
cover 'S_3_gSb@_:
e7<_ s eves _/6_' es I_symede
Store similar foods together and adjust the shelves to fit
different heights. This reduces the time the refrigerator door is
open and saves energy.
To Remove and Replace a Shelf..
1. Pull the shelf forward to the stop. Tilt the front of the shelf up
and lift it slightly as you pull the shelf from the frame.
Your model may have some or all of these features. Features
that can be purchased separately as product accessories are
labeled with the word "Accessory." Not all accessories will fit all
models. If you are interested in purchasing one of the
accessories, please call the toll-free number on the back cover
or in the "Accessories" section.
Important information to know about glass shelves
and covers:
Do not olean glass shelves or oovers with warm water when
they are oold. Shelves and oovers may break if exposed to
sudden temperature ohanges or impaot, suoh as bumping.
Tempered glass is designed to shatter into many small,
pebble-size pieoes. This is normal. Glass shelves and oovers
are heavy. Use both hands when removing them to avoid
dropping.
(e_ some modes}
To Remove and Replace the Bins..
1. Remove the bin by lifting it and pulling it straight out.
2. Replace the bin by sliding it in above the desired supports
and pushing it down until it stops.
2.
Replace the shelf by guiding it back into the slots on the
frame and pushing the shelf in past the stop.
k
/ \
Wse Rack
(os'ssome modes}
The wine rack can be placed on any set of refrigerator shelf
supports, either with (as shown below) or without a shelf on the
same supports.
I
NOTE: If the wine rack is sharing a set of supports with a shelf,
you must first remove the shelf in order to remove the wine rack.
23