Kenmore 106.5117 Use & Care Manual page 16

Remove the Produce Preserver pouches from their
packaging.
n!rl
Produce, ' re, s e vet
CAUTION CUIDADO
IRRITANT IRRITANTE
2. Lift up on the housing in order to remove it from its mounting
tab along the wall.
3. Open the housing by pulling up and out on the back of the
top of the housing.
4. Place both pouches inside the housing, then snap the housing
back together.
5. Place the housing back on the mounting tab along the wall.
Installing the Status Indicator (on some models)
The Produce Preserver comes with a status indicator, which
should be activated and installed at the same time the pouch is
installed.
1. Place the indicator face-down on a firm, flat surface.
2. Apply pressure to the bubble on the back of the indicator,
until the bubble pops to activate the indicator.
3. Slide open the cap on the Produce Preserver housing.
4. Place the indicator in the top of the housing, facing outward.
5. Slide the cap closed, and check that the indicator is visible
through the rectangular hole in the cap.
NOTE: The cap will not easily close if the indicator's rear
bubble has not been popped.
Replacing the Produce Preserver (on some models)
The disposable pouches should be replaced every 6 months,
when the status indicator has completely changed from white to
red.
.
2.
3.
To order replacements, see "Accessories."
Remove the old pouches from the Produce Preserver
housing.
Remove the old status indicator.
Install the new pouches and status indicator using the
instructions in the previous sections.
REFRIGERATOR USE
In order to ensure proper temperatures, you need to permit air
to flow between the two sections. Cold air enters the bottom of
the freezer section and moves up. It then enters the refrigerator
section through the top vent. (On Style 2 models, this air is also
evenly distributed throughout the refrigerator compartment
through six vents on the back wall.) Air then returns to the
freezer as shown.
Style 1 Style 2
Do not block any of these vents with food such as soda, cereal,
bread, etc. If the vents are blocked, airflow will be obstructed
and temperature and moisture problems may occur.
IMPORTANT: Because air circulates between both sections, any
odors formed in one section will transfer to the other. You must
thoroughly clean both sections to eliminate odors. To avoid odor
transfer and drying out of food, wrap or cover foods tightly.
The refrigerator and freezer controls are located on the
dispenser panel.
IMPORTANT: The display screen on the dispenser control panel
will turn off automatically and enter "sleep" mode when the
control buttons and dispenser pad have not been used for
2 minutes or more. While in "sleep" mode, the first press of a
control button will only reactivate the display screen, without
changing any settings.
• Touch any control button on the dispenser panel to activate
the display screen. The home screen will appear as shown.
16