Advertisement
TROUBLE-SHOOTING
AND MAINTENANCE
Most treadmill problems can be solved by following the simple steps below. Find the symptom that applies, and fol-
low the stepslisted. If further assistance is needed, call our toll-free HOTUNE at 1-800-736-6879,
Monday through
Saturday, 7 a.m. until 7 p.m. Central Time (excluding holidays).
1. SYMPTOM: THE POWER DOES NOT TURN ON
a. Make sure that the power cord is plugged in properly. (See PLUGGING IN THE POWER CORD on page 6.) If an
extension cord is needed, use only a 14-gauge general-purpose cord of five feet or less in length.
b. Make sure that the safety key is inserted fully into the console. Turn the speed control knob to the "reset" position.
(See DIAGRAM OF THE CONSOLE on page 7.)
C°
Check the circuit breaker located on the front of the frame. The
circuit breaker is designed to protect the electrical system.If the
circuit breaker has tripped, the switch wil! protrude as shown.
To reset the circuit breaker, allow the CROSS WALK to cool for
five minutes, and then push the switch back in.
Tripped
Reset
2. SYMPTOM: THE POWER TURNS OFF DURING USE
a. Make sure that the power cord is plugged in.
b. Check the circuit breaker located on the front of the frame. If the circuit breaker has tripped, the switch will pro-
trude. (See the drawing above.) To reset the circuit breaker, allow the CROSS WALK to cool for five minutes, and
then pushthe switchback in.
c. Remove the safety key from the console. Reinsertthe safety key fully into the console.Turn the speed control knob
to the "RESET"position.
3. SYMPTOM: THE MOTIVATIONAL FITNESSMONITOR DOES NOT FUNCTION PROPERLY
a. Check the batteries in the console. (See INSTAllING BATTERIES on page 7.) Most problemsare the resultof
drained batteries.
4. SYMPTOM: THE CROSS WALK DOES NOT INCLINE
a. Stand at the back of the foot rails while increasing the incline. Stand at the front of the foot rails and lean forward
while decreasing the incline. You may need to raise and lower the treadmill several timesto break in the incline
shock. (See CHANGING THE INCUNE on page 8.)
5. SYMPTOM: THE WALlaNG BELT SLOWS WHEN WALKED ON
a. Silicone lubricant mustbe applied to the walking platform before the CROSS WALK is used. Lubricantshould be
reapplied after every 10 hoursof use, and whenever a decrease in performance is noticed. (See APPLYING SIU-
CONE LUBRICANTon page 6 for application instructions.) Uni*Sport silicone spray is recommended. CAUTION:
ALWAYS UNPLUG THE POWER CORD WHEN APPLYING LUBRICANT.
b. If an extension cord is
needed, use
only a 14-gauge general-purpose cord of five feet or lessin length.
9
Advertisement
